Applying to long network, stacked paper machine pressure portions, including single room double chambers or three chambers, pre-pressing main pressure, pipetting press, three roller two pressure, two roller two pressure, four roller three pressure, boots type press. Representative model: Net paper width 5600mm, speed 1000m / min.
Roller: stainless steel 304/2205 roll pipe, imported double-phase stainless steel cast, wall thickness 45 ~ 85mm, roller bore φ4.5mm
Glue surface: polyurethane or wear-resistant rubber, thickness 20mm, hardness P & J 10 +/- 2 ° or "a" 96 +/- 2 °, glue surface diamond φ4mm via, the opening ratio is about 15%, can increase blind according to requirements Hole or groove.
Vacuum box: box stainless steel 304 welding, single room double chamber or three chambers, can be overall, built-in seal, lubrication, cleaning, amplitude modulation assembly, all of which are stainless steel 304, configured inlet gas, graphite sealing strip. The high pressure moving water spray cleaning device can be optionally.
Shaft head, bearing housing: ductile iron, cast steel, forgings.
Bearings: SKF, TIMKEN, FAG, NSK, ZWZ, grease lubrication or dilute oil lubrication.
Drive mode: key drive, gear drive, no transmission.
Quality Assurance: After assembly, the whole ride balance detection, roller surface beating detection, and simulation trial operation.